2 tristate "WILC1000 support (WiFi only)"
5 depends on CFG80211 && WEXT_CORE && INET
8 This module only support IEEE 802.11n WiFi.
11 prompt "Memory Allocation"
13 default WILC1000_PREALLOCATE_AT_LOADING_DRIVER
15 config WILC1000_PREALLOCATE_AT_LOADING_DRIVER
16 bool "Preallocate memory at loading driver"
18 This choice supports static allocation of the memory
19 for the receive buffer. The driver will allocate the RX buffer
20 during initial time. The driver will also free the buffer
21 by calling network device stop.
23 config WILC1000_DYNAMICALLY_ALLOCATE_MEMROY
24 bool "Dynamically allocate memory in real time"
26 This choice supports dynamic allocation of the memory
27 for the receive buffer. The driver will allocate the RX buffer
40 This module adds support for the SDIO interface of adapters using
41 WILC1000 chipset. The Atmel WILC1000 SDIO is a full speed interface.
42 It meets SDIO card specification version 2.0. The interface supports
43 the 1-bit/4-bit SD transfer mode at the clock range of 0-50 MHz.
44 The host can use this interface to read and write from any register
45 within the chip as well as configure the WILC1000 for data DMA.
46 To use this interface, pin9 (SDIO_SPI_CFG) must be grounded. Select
47 this if your platform is using the SDIO bus.
53 This module adds support for the SPI interface of adapters using
54 WILC1000 chipset. The Atmel WILC1000 has a Serial Peripheral
55 Interface (SPI) that operates as a SPI slave. This SPI interface can
56 be used for control and for serial I/O of 802.11 data. The SPI is a
57 full-duplex slave synchronous serial interface that is available
58 immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
59 VDDIO. Select this if your platform is using the SPI bus.
62 config WILC1000_HW_OOB_INTR
63 bool "Use out of band interrupt"
64 depends on WILC1000 && WILC1000_SDIO
67 This option enables out-of-band interrupt support for the WILC1000
68 chipset. This OOB interrupt is intended to provide a faster interrupt
69 mechanism for SDIO host controllers that don't support SDIO interrupt.
70 Select this option If the SDIO host controller in your platform
71 doesn't support SDIO time devision interrupt.