Minimum time-to-live of entries. Should be enough to cover fragment
time-to-live on the reassembling side. This minimum time-to-live is
guaranteed if the pool size is less than inet_peer_threshold.
- Measured in jiffies(1).
+ Measured in seconds.
inet_peer_maxttl - INTEGER
Maximum time-to-live of entries. Unused entries will expire after
this period of time if there is no memory pressure on the pool (i.e.
when the number of entries in the pool is very small).
- Measured in jiffies(1).
+ Measured in seconds.
inet_peer_gc_mintime - INTEGER
Minimum interval between garbage collection passes. This interval is
in effect under high memory pressure on the pool.
- Measured in jiffies(1).
+ Measured in seconds.
inet_peer_gc_maxtime - INTEGER
Minimum interval between garbage collection passes. This interval is
in effect under low (or absent) memory pressure on the pool.
- Measured in jiffies(1).
+ Measured in seconds.
TCP variables:
F-RTO is an enhanced recovery algorithm for TCP retransmission
timeouts. It is particularly beneficial in wireless environments
where packet loss is typically due to random radio interference
- rather than intermediate router congestion. FRTO is sender-side
+ rather than intermediate router congestion. F-RTO is sender-side
only modification. Therefore it does not require any support from
the peer, but in a typical case, however, where wireless link is
the local access link and most of the data flows downlink, the
- faraway servers should have FRTO enabled to take advantage of it.
+ faraway servers should have F-RTO enabled to take advantage of it.
If set to 1, basic version is enabled. 2 enables SACK enhanced
F-RTO if flow uses SACK. The basic version can be used also when
- SACK is in use though scenario(s) with it exists where FRTO
+ SACK is in use though scenario(s) with it exists where F-RTO
interacts badly with the packet counting of the SACK enabled TCP
flow.
and CONFIG_NET_DMA is enabled.
Default: 4096
+UDP variables:
+
+udp_mem - vector of 3 INTEGERs: min, pressure, max
+ Number of pages allowed for queueing by all UDP sockets.
+
+ min: Below this number of pages UDP is not bothered about its
+ memory appetite. When amount of memory allocated by UDP exceeds
+ this number, UDP starts to moderate memory usage.
+
+ pressure: This value was introduced to follow format of tcp_mem.
+
+ max: Number of pages allowed for queueing by all UDP sockets.
+
+ Default is calculated at boot time from amount of available memory.
+
+udp_rmem_min - INTEGER
+ Minimal size of receive buffer used by UDP sockets in moderation.
+ Each UDP socket is able to use the size for receiving data, even if
+ total pages of UDP sockets exceed udp_mem pressure. The unit is byte.
+ Default: 4096
+
+udp_wmem_min - INTEGER
+ Minimal size of send buffer used by UDP sockets in moderation.
+ Each UDP socket is able to use the size for sending data, even if
+ total pages of UDP sockets exceed udp_mem pressure. The unit is byte.
+ Default: 4096
+
CIPSOv4 Variables:
cipso_cache_enable - BOOLEAN
Allows you to write a number, which can be used as required.
Default value is 0.
-(1) Jiffie: internal timeunit for the kernel. On the i386 1/100s, on the
-Alpha 1/1024s. See the HZ define in /usr/include/asm/param.h for the exact
-value on your system.
-
Alexey Kuznetsov.
kuznet@ms2.inr.ac.ru
Default: 1
+proc/sys/net/sctp/* Variables:
+
+addip_enable - BOOLEAN
+ Enable or disable extension of Dynamic Address Reconfiguration
+ (ADD-IP) functionality specified in RFC5061. This extension provides
+ the ability to dynamically add and remove new addresses for the SCTP
+ associations.
+
+ 1: Enable extension.
+
+ 0: Disable extension.
+
+ Default: 0
+
+addip_noauth_enable - BOOLEAN
+ Dynamic Address Reconfiguration (ADD-IP) requires the use of
+ authentication to protect the operations of adding or removing new
+ addresses. This requirement is mandated so that unauthorized hosts
+ would not be able to hijack associations. However, older
+ implementations may not have implemented this requirement while
+ allowing the ADD-IP extension. For reasons of interoperability,
+ we provide this variable to control the enforcement of the
+ authentication requirement.
+
+ 1: Allow ADD-IP extension to be used without authentication. This
+ should only be set in a closed environment for interoperability
+ with older implementations.
+
+ 0: Enforce the authentication requirement
+
+ Default: 0
+
+auth_enable - BOOLEAN
+ Enable or disable Authenticated Chunks extension. This extension
+ provides the ability to send and receive authenticated chunks and is
+ required for secure operation of Dynamic Address Reconfiguration
+ (ADD-IP) extension.
+
+ 1: Enable this extension.
+ 0: Disable this extension.
+
+ Default: 0
+
+prsctp_enable - BOOLEAN
+ Enable or disable the Partial Reliability extension (RFC3758) which
+ is used to notify peers that a given DATA should no longer be expected.
+
+ 1: Enable extension
+ 0: Disable
+
+ Default: 1
+
+max_burst - INTEGER
+ The limit of the number of new packets that can be initially sent. It
+ controls how bursty the generated traffic can be.
+
+ Default: 4
+
+association_max_retrans - INTEGER
+ Set the maximum number for retransmissions that an association can
+ attempt deciding that the remote end is unreachable. If this value
+ is exceeded, the association is terminated.
+
+ Default: 10
+
+max_init_retransmits - INTEGER
+ The maximum number of retransmissions of INIT and COOKIE-ECHO chunks
+ that an association will attempt before declaring the destination
+ unreachable and terminating.
+
+ Default: 8
+
+path_max_retrans - INTEGER
+ The maximum number of retransmissions that will be attempted on a given
+ path. Once this threshold is exceeded, the path is considered
+ unreachable, and new traffic will use a different path when the
+ association is multihomed.
+
+ Default: 5
+
+rto_initial - INTEGER
+ The initial round trip timeout value in milliseconds that will be used
+ in calculating round trip times. This is the initial time interval
+ for retransmissions.
+
+ Default: 3000
+
+rto_max - INTEGER
+ The maximum value (in milliseconds) of the round trip timeout. This
+ is the largest time interval that can elapse between retransmissions.
+
+ Default: 60000
+
+rto_min - INTEGER
+ The minimum value (in milliseconds) of the round trip timeout. This
+ is the smallest time interval the can elapse between retransmissions.
+
+ Default: 1000
+
+hb_interval - INTEGER
+ The interval (in milliseconds) between HEARTBEAT chunks. These chunks
+ are sent at the specified interval on idle paths to probe the state of
+ a given path between 2 associations.
+
+ Default: 30000
+
+sack_timeout - INTEGER
+ The amount of time (in milliseconds) that the implementation will wait
+ to send a SACK.
+
+ Default: 200
+
+valid_cookie_life - INTEGER
+ The default lifetime of the SCTP cookie (in milliseconds). The cookie
+ is used during association establishment.
+
+ Default: 60000
+
+cookie_preserve_enable - BOOLEAN
+ Enable or disable the ability to extend the lifetime of the SCTP cookie
+ that is used during the establishment phase of SCTP association
+
+ 1: Enable cookie lifetime extension.
+ 0: Disable
+
+ Default: 1
+
+rcvbuf_policy - INTEGER
+ Determines if the receive buffer is attributed to the socket or to
+ association. SCTP supports the capability to create multiple
+ associations on a single socket. When using this capability, it is
+ possible that a single stalled association that's buffering a lot
+ of data may block other associations from delivering their data by
+ consuming all of the receive buffer space. To work around this,
+ the rcvbuf_policy could be set to attribute the receiver buffer space
+ to each association instead of the socket. This prevents the described
+ blocking.
+
+ 1: rcvbuf space is per association
+ 0: recbuf space is per socket
+
+ Default: 0
+
+sndbuf_policy - INTEGER
+ Similar to rcvbuf_policy above, this applies to send buffer space.
+
+ 1: Send buffer is tracked per association
+ 0: Send buffer is tracked per socket.
+
+ Default: 0
+
+sctp_mem - vector of 3 INTEGERs: min, pressure, max
+ Number of pages allowed for queueing by all SCTP sockets.
+
+ min: Below this number of pages SCTP is not bothered about its
+ memory appetite. When amount of memory allocated by SCTP exceeds
+ this number, SCTP starts to moderate memory usage.
+
+ pressure: This value was introduced to follow format of tcp_mem.
+
+ max: Number of pages allowed for queueing by all SCTP sockets.
+
+ Default is calculated at boot time from amount of available memory.
+
+sctp_rmem - vector of 3 INTEGERs: min, default, max
+ See tcp_rmem for a description.
+
+sctp_wmem - vector of 3 INTEGERs: min, default, max
+ See tcp_wmem for a description.
+
UNDOCUMENTED:
dev_weight FIXME
projects / firefly-linux-kernel-4.4.55.git / blobdiff