u32 pfit_control;
u32 pfit_pgm_ratios;
bool pfit_dirty;
+ bool is_dual_link;
+ u32 reg;
struct intel_lvds_connector *attached_connector;
};
{
struct drm_device *dev = encoder->base.dev;
struct drm_i915_private *dev_priv = dev->dev_private;
- u32 lvds_reg, tmp;
-
- if (HAS_PCH_SPLIT(dev)) {
- lvds_reg = PCH_LVDS;
- } else {
- lvds_reg = LVDS;
- }
+ struct intel_lvds_encoder *lvds_encoder = to_lvds_encoder(&encoder->base);
+ u32 tmp;
- tmp = I915_READ(lvds_reg);
+ tmp = I915_READ(lvds_encoder->reg);
if (!(tmp & LVDS_PORT_EN))
return false;
return true;
}
+/* The LVDS pin pair needs to be on before the DPLLs are enabled.
+ * This is an exception to the general rule that mode_set doesn't turn
+ * things on.
+ */
+static void intel_pre_pll_enable_lvds(struct intel_encoder *encoder)
+{
+ struct intel_lvds_encoder *lvds_encoder = to_lvds_encoder(&encoder->base);
+ struct drm_device *dev = encoder->base.dev;
+ struct drm_i915_private *dev_priv = dev->dev_private;
+ struct intel_crtc *intel_crtc = to_intel_crtc(encoder->base.crtc);
+ struct drm_display_mode *fixed_mode =
+ lvds_encoder->attached_connector->base.panel.fixed_mode;
+ int pipe = intel_crtc->pipe;
+ u32 temp;
+
+ temp = I915_READ(lvds_encoder->reg);
+ temp |= LVDS_PORT_EN | LVDS_A0A2_CLKA_POWER_UP;
+
+ if (HAS_PCH_CPT(dev)) {
+ temp &= ~PORT_TRANS_SEL_MASK;
+ temp |= PORT_TRANS_SEL_CPT(pipe);
+ } else {
+ if (pipe == 1) {
+ temp |= LVDS_PIPEB_SELECT;
+ } else {
+ temp &= ~LVDS_PIPEB_SELECT;
+ }
+ }
+
+ /* set the corresponsding LVDS_BORDER bit */
+ temp |= dev_priv->lvds_border_bits;
+ /* Set the B0-B3 data pairs corresponding to whether we're going to
+ * set the DPLLs for dual-channel mode or not.
+ */
+ if (lvds_encoder->is_dual_link)
+ temp |= LVDS_B0B3_POWER_UP | LVDS_CLKB_POWER_UP;
+ else
+ temp &= ~(LVDS_B0B3_POWER_UP | LVDS_CLKB_POWER_UP);
+
+ /* It would be nice to set 24 vs 18-bit mode (LVDS_A3_POWER_UP)
+ * appropriately here, but we need to look more thoroughly into how
+ * panels behave in the two modes.
+ */
+
+ /* Set the dithering flag on LVDS as needed, note that there is no
+ * special lvds dither control bit on pch-split platforms, dithering is
+ * only controlled through the PIPECONF reg. */
+ if (INTEL_INFO(dev)->gen == 4) {
+ if (dev_priv->lvds_dither)
+ temp |= LVDS_ENABLE_DITHER;
+ else
+ temp &= ~LVDS_ENABLE_DITHER;
+ }
+ temp &= ~(LVDS_HSYNC_POLARITY | LVDS_VSYNC_POLARITY);
+ if (fixed_mode->flags & DRM_MODE_FLAG_NHSYNC)
+ temp |= LVDS_HSYNC_POLARITY;
+ if (fixed_mode->flags & DRM_MODE_FLAG_NVSYNC)
+ temp |= LVDS_VSYNC_POLARITY;
+
+ I915_WRITE(lvds_encoder->reg, temp);
+}
+
/**
* Sets the power state for the panel.
*/
struct intel_lvds_encoder *lvds_encoder = to_lvds_encoder(&encoder->base);
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->base.crtc);
struct drm_i915_private *dev_priv = dev->dev_private;
- u32 ctl_reg, lvds_reg, stat_reg;
+ u32 ctl_reg, stat_reg;
if (HAS_PCH_SPLIT(dev)) {
ctl_reg = PCH_PP_CONTROL;
- lvds_reg = PCH_LVDS;
stat_reg = PCH_PP_STATUS;
} else {
ctl_reg = PP_CONTROL;
- lvds_reg = LVDS;
stat_reg = PP_STATUS;
}
- I915_WRITE(lvds_reg, I915_READ(lvds_reg) | LVDS_PORT_EN);
+ I915_WRITE(lvds_encoder->reg, I915_READ(lvds_encoder->reg) | LVDS_PORT_EN);
if (lvds_encoder->pfit_dirty) {
/*
}
I915_WRITE(ctl_reg, I915_READ(ctl_reg) | POWER_TARGET_ON);
- POSTING_READ(lvds_reg);
+ POSTING_READ(lvds_encoder->reg);
if (wait_for((I915_READ(stat_reg) & PP_ON) != 0, 1000))
DRM_ERROR("timed out waiting for panel to power on\n");
struct drm_device *dev = encoder->base.dev;
struct intel_lvds_encoder *lvds_encoder = to_lvds_encoder(&encoder->base);
struct drm_i915_private *dev_priv = dev->dev_private;
- u32 ctl_reg, lvds_reg, stat_reg;
+ u32 ctl_reg, stat_reg;
if (HAS_PCH_SPLIT(dev)) {
ctl_reg = PCH_PP_CONTROL;
- lvds_reg = PCH_LVDS;
stat_reg = PCH_PP_STATUS;
} else {
ctl_reg = PP_CONTROL;
- lvds_reg = LVDS;
stat_reg = PP_STATUS;
}
lvds_encoder->pfit_dirty = true;
}
- I915_WRITE(lvds_reg, I915_READ(lvds_reg) & ~LVDS_PORT_EN);
- POSTING_READ(lvds_reg);
+ I915_WRITE(lvds_encoder->reg, I915_READ(lvds_encoder->reg) & ~LVDS_PORT_EN);
+ POSTING_READ(lvds_encoder->reg);
}
static int intel_lvds_mode_valid(struct drm_connector *connector,
dev_priv->modeset_on_lid = 0;
mutex_lock(&dev->mode_config.mutex);
- intel_modeset_check_state(dev);
+ intel_modeset_setup_hw_state(dev, true);
mutex_unlock(&dev->mode_config.mutex);
return NOTIFY_OK;
* If the CRTC is enabled, the display will be changed
* according to the new panel fitting mode.
*/
- intel_set_mode(crtc, &crtc->mode,
- crtc->x, crtc->y, crtc->fb);
+ intel_crtc_restore_mode(crtc);
}
}
return false;
}
+static int intel_dual_link_lvds_callback(const struct dmi_system_id *id)
+{
+ DRM_INFO("Forcing lvds to dual link mode on %s\n", id->ident);
+ return 1;
+}
+
+static const struct dmi_system_id intel_dual_link_lvds[] = {
+ {
+ .callback = intel_dual_link_lvds_callback,
+ .ident = "Apple MacBook Pro (Core i5/i7 Series)",
+ .matches = {
+ DMI_MATCH(DMI_SYS_VENDOR, "Apple Inc."),
+ DMI_MATCH(DMI_PRODUCT_NAME, "MacBookPro8,2"),
+ },
+ },
+ { } /* terminating entry */
+};
+
+bool intel_is_dual_link_lvds(struct drm_device *dev)
+{
+ struct intel_encoder *encoder;
+ struct intel_lvds_encoder *lvds_encoder;
+
+ list_for_each_entry(encoder, &dev->mode_config.encoder_list,
+ base.head) {
+ if (encoder->type == INTEL_OUTPUT_LVDS) {
+ lvds_encoder = to_lvds_encoder(&encoder->base);
+
+ return lvds_encoder->is_dual_link;
+ }
+ }
+
+ return false;
+}
+
+static bool compute_is_dual_link_lvds(struct intel_lvds_encoder *lvds_encoder)
+{
+ struct drm_device *dev = lvds_encoder->base.base.dev;
+ unsigned int val;
+ struct drm_i915_private *dev_priv = dev->dev_private;
+
+ /* use the module option value if specified */
+ if (i915_lvds_channel_mode > 0)
+ return i915_lvds_channel_mode == 2;
+
+ if (dmi_check_system(intel_dual_link_lvds))
+ return true;
+
+ /* BIOS should set the proper LVDS register value at boot, but
+ * in reality, it doesn't set the value when the lid is closed;
+ * we need to check "the value to be set" in VBT when LVDS
+ * register is uninitialized.
+ */
+ val = I915_READ(lvds_encoder->reg);
+ if (!(val & ~(LVDS_PIPE_MASK | LVDS_DETECTED)))
+ val = dev_priv->bios_lvds_val;
+
+ return (val & LVDS_CLKB_POWER_MASK) == LVDS_CLKB_POWER_UP;
+}
+
static bool intel_lvds_supported(struct drm_device *dev)
{
/* With the introduction of the PCH we gained a dedicated
DRM_MODE_ENCODER_LVDS);
intel_encoder->enable = intel_enable_lvds;
+ intel_encoder->pre_pll_enable = intel_pre_pll_enable_lvds;
intel_encoder->disable = intel_disable_lvds;
intel_encoder->get_hw_state = intel_lvds_get_hw_state;
intel_connector->get_hw_state = intel_connector_get_hw_state;
connector->interlace_allowed = false;
connector->doublescan_allowed = false;
+ if (HAS_PCH_SPLIT(dev)) {
+ lvds_encoder->reg = PCH_LVDS;
+ } else {
+ lvds_encoder->reg = LVDS;
+ }
+
/* create the scaling mode property */
drm_mode_create_scaling_mode_property(dev);
drm_object_attach_property(&connector->base,
list_for_each_entry(scan, &connector->probed_modes, head) {
if (scan->type & DRM_MODE_TYPE_PREFERRED) {
+ DRM_DEBUG_KMS("using preferred mode from EDID: ");
+ drm_mode_debug_printmodeline(scan);
+
fixed_mode = drm_mode_duplicate(dev, scan);
- intel_find_lvds_downclock(dev, fixed_mode, connector);
- goto out;
+ if (fixed_mode) {
+ intel_find_lvds_downclock(dev, fixed_mode,
+ connector);
+ goto out;
+ }
}
}
/* Failed to get EDID, what about VBT? */
if (dev_priv->lfp_lvds_vbt_mode) {
+ DRM_DEBUG_KMS("using mode from VBT: ");
+ drm_mode_debug_printmodeline(dev_priv->lfp_lvds_vbt_mode);
+
fixed_mode = drm_mode_duplicate(dev, dev_priv->lfp_lvds_vbt_mode);
if (fixed_mode) {
fixed_mode->type |= DRM_MODE_TYPE_PREFERRED;
if (crtc && (lvds & LVDS_PORT_EN)) {
fixed_mode = intel_crtc_mode_get(dev, crtc);
if (fixed_mode) {
+ DRM_DEBUG_KMS("using current (BIOS) mode: ");
+ drm_mode_debug_printmodeline(fixed_mode);
fixed_mode->type |= DRM_MODE_TYPE_PREFERRED;
goto out;
}
goto failed;
out:
+ lvds_encoder->is_dual_link = compute_is_dual_link_lvds(lvds_encoder);
+ DRM_DEBUG_KMS("detected %s-link lvds configuration\n",
+ lvds_encoder->is_dual_link ? "dual" : "single");
+
/*
* Unlock registers and just
* leave them unlocked