static const int abituguru_pwm_settings_multiplier[5] = { 0, 1, 1, 1000, 1000 };
/*
* Min / Max allowed values for pwm_settings. Note: pwm1 (CPU fan) is a
- * special case the minium allowed pwm% setting for this is 30% (77) on
+ * special case the minimum allowed pwm% setting for this is 30% (77) on
* some MB's this special case is handled in the code!
*/
static const u8 abituguru_pwm_min[5] = { 0, 170, 170, 25, 25 };
ABIT_UGURU_DEBUG(2, "testing bank1 sensor %d\n", (int)sensor_addr);
/*
- * Volt sensor test, enable volt low alarm, set min value ridicously
+ * Volt sensor test, enable volt low alarm, set min value ridiculously
* high, or vica versa if the reading is very high. If its a volt
* sensor this should always give us an alarm.
*/
/*
* Temp sensor test, enable sensor as a temp sensor, set beep value
- * ridicously low (but not too low, otherwise uguru ignores it).
+ * ridiculously low (but not too low, otherwise uguru ignores it).
* If its a temp sensor this should always give us an alarm.
*/
buf[0] = ABIT_UGURU_TEMP_HIGH_ALARM_ENABLE;
pr_info("found Abit uGuru\n");
/* Register sysfs hooks */
- for (i = 0; i < sysfs_attr_i; i++)
- if (device_create_file(&pdev->dev,
- &data->sysfs_attr[i].dev_attr))
+ for (i = 0; i < sysfs_attr_i; i++) {
+ res = device_create_file(&pdev->dev,
+ &data->sysfs_attr[i].dev_attr);
+ if (res)
goto abituguru_probe_error;
- for (i = 0; i < ARRAY_SIZE(abituguru_sysfs_attr); i++)
- if (device_create_file(&pdev->dev,
- &abituguru_sysfs_attr[i].dev_attr))
+ }
+ for (i = 0; i < ARRAY_SIZE(abituguru_sysfs_attr); i++) {
+ res = device_create_file(&pdev->dev,
+ &abituguru_sysfs_attr[i].dev_attr);
+ if (res)
goto abituguru_probe_error;
+ }
data->hwmon_dev = hwmon_device_register(&pdev->dev);
if (!IS_ERR(data->hwmon_dev))