int ring_offset);
static void el2_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr,
int ring_page);
-static struct ethtool_ops netdev_ethtool_ops;
+static const struct ethtool_ops netdev_ethtool_ops;
+
-\f
/* This routine probes for a memory-mapped 3c503 board by looking for
the "location register" at the end of the jumpered boot PROM space.
This works even if a PROM isn't there.
int irq = dev->irq;
SET_MODULE_OWNER(dev);
-
+
if (base_addr > 0x1ff) /* Check a single specified location. */
return el2_probe1(dev, base_addr);
else if (base_addr != 0) /* Don't probe at all. */
/* Try all of the locations that aren't obviously empty. This touches
a lot of locations, and is much riskier than the code above. */
-static int __init
+static int __init
el2_pio_probe(struct net_device *dev)
{
int i;
return -ENODEV;
}
-static void cleanup_card(struct net_device *dev)
-{
- /* NB: el2_close() handles free_irq */
- release_region(dev->base_addr, EL2_IO_EXTENT);
- if (ei_status.mem)
- iounmap(ei_status.mem);
-}
-
#ifndef MODULE
struct net_device * __init el2_probe(int unit)
{
/* Probe for the Etherlink II card at I/O port base IOADDR,
returning non-zero on success. If found, set the station
address and memory parameters in DEVICE. */
-static int __init
+static int __init
el2_probe1(struct net_device *dev, int ioaddr)
{
int i, iobase_reg, membase_reg, saved_406, wordlength, retval;
release_region(ioaddr, EL2_IO_EXTENT);
return retval;
}
-\f
+
static int
el2_open(struct net_device *dev)
{
outb_p(0x04 << ((*irqp == 9) ? 2 : *irqp), E33G_IDCFR);
outb_p(0x00, E33G_IDCFR);
if (*irqp == probe_irq_off(cookie) /* It's a good IRQ line! */
- && ((retval = request_irq(dev->irq = *irqp,
+ && ((retval = request_irq(dev->irq = *irqp,
ei_interrupt, 0, dev->name, dev)) == 0))
break;
}
sprintf(info->bus_info, "ISA 0x%lx", dev->base_addr);
}
-static struct ethtool_ops netdev_ethtool_ops = {
+static const struct ethtool_ops netdev_ethtool_ops = {
.get_drvinfo = netdev_get_drvinfo,
};
/* This is set up so that only a single autoprobe takes place per call.
ISA device autoprobes on a running machine are not recommended. */
-int
+int __init
init_module(void)
{
struct net_device *dev;
return -ENXIO;
}
+static void cleanup_card(struct net_device *dev)
+{
+ /* NB: el2_close() handles free_irq */
+ release_region(dev->base_addr, EL2_IO_EXTENT);
+ if (ei_status.mem)
+ iounmap(ei_status.mem);
+}
+
void
cleanup_module(void)
{