include/linux/poison.h: remove not-used poison pointer macros

[firefly-linux-kernel-4.4.55.git] / include / linux / usb.h

diff --git a/include/linux/usb.h b/include/linux/usb.h
index 7ee1b5c3b4cbb71f53c9e1d32c3eb92c8c6c6d45..447fe29b55b451148c452b82cb0043d510a26eae 100644 (file)
--- a/include/linux/usb.h
+++ b/include/linux/usb.h
@@ -205,6 +205,32 @@ void usb_put_intf(struct usb_interface *intf);
 #define USB_MAXINTERFACES      32
 #define USB_MAXIADS            (USB_MAXINTERFACES/2)
 
+/*
+ * USB Resume Timer: Every Host controller driver should drive the resume
+ * signalling on the bus for the amount of time defined by this macro.
+ *
+ * That way we will have a 'stable' behavior among all HCDs supported by Linux.
+ *
+ * Note that the USB Specification states we should drive resume for *at least*
+ * 20 ms, but it doesn't give an upper bound. This creates two possible
+ * situations which we want to avoid:
+ *
+ * (a) sometimes an msleep(20) might expire slightly before 20 ms, which causes
+ * us to fail USB Electrical Tests, thus failing Certification
+ *
+ * (b) Some (many) devices actually need more than 20 ms of resume signalling,
+ * and while we can argue that's against the USB Specification, we don't have
+ * control over which devices a certification laboratory will be using for
+ * certification. If CertLab uses a device which was tested against Windows and
+ * that happens to have relaxed resume signalling rules, we might fall into
+ * situations where we fail interoperability and electrical tests.
+ *
+ * In order to avoid both conditions, we're using a 40 ms resume timeout, which
+ * should cope with both LPJ calibration errors and devices not following every
+ * detail of the USB Specification.
+ */
+#define USB_RESUME_TIMEOUT     40 /* ms */
+
 /**
  * struct usb_interface_cache - long-term representation of a device interface
  * @num_altsetting: number of altsettings defined.