* USB hubs. That makes it stay the same until systems are physically
* reconfigured, by re-cabling a tree of USB devices or by moving USB host
* controllers. Adding and removing devices, including virtual root hubs
- * in host controller driver modules, does not change these path identifers;
+ * in host controller driver modules, does not change these path identifiers;
* neither does rebooting or re-enumerating. These are more useful identifiers
* than changeable ("unstable") ones like bus numbers or device addresses.
*
* usb_set_intfdata() to associate driver-specific data with the
* interface. It may also use usb_set_interface() to specify the
* appropriate altsetting. If unwilling to manage the interface,
- * return -ENODEV, if genuine IO errors occured, an appropriate
+ * return -ENODEV, if genuine IO errors occurred, an appropriate
* negative errno value.
* @disconnect: Called when the interface is no longer accessible, usually
* because its device has been (or is being) disconnected or the
* @resume: Called when the device is being resumed by the system.
* @reset_resume: Called when the suspended device has been reset instead
* of being resumed.
- * @pre_reset: Called by usb_reset_device() when the device
- * is about to be reset.
+ * @pre_reset: Called by usb_reset_device() when the device is about to be
+ * reset. This routine must not return until the driver has no active
+ * URBs for the device, and no more URBs may be submitted until the
+ * post_reset method is called.
* @post_reset: Called by usb_reset_device() after the device
* has been reset
* @id_table: USB drivers use ID table to support hotplugging.