+
+ /* Load new GDT with the 64bit segments using 32bit descriptor */
+ leal gdt(%ebp), %eax
+ movl %eax, gdt+2(%ebp)
+ lgdt gdt(%ebp)
+
+ /* Enable PAE mode */
+ xorl %eax, %eax
+ orl $(1 << 5), %eax
+ movl %eax, %cr4
+
+ /*
+ * Build early 4G boot pagetable
+ */
+ /* Initialize Page tables to 0*/
+ leal pgtable(%ebx), %edi
+ xorl %eax, %eax
+ movl $((4096*6)/4), %ecx
+ rep stosl
+
+ /* Build Level 4 */
+ leal pgtable + 0(%ebx), %edi
+ leal 0x1007 (%edi), %eax
+ movl %eax, 0(%edi)
+
+ /* Build Level 3 */
+ leal pgtable + 0x1000(%ebx), %edi
+ leal 0x1007(%edi), %eax
+ movl $4, %ecx
+1: movl %eax, 0x00(%edi)
+ addl $0x00001000, %eax
+ addl $8, %edi
+ decl %ecx
+ jnz 1b
+
+ /* Build Level 2 */
+ leal pgtable + 0x2000(%ebx), %edi
+ movl $0x00000183, %eax
+ movl $2048, %ecx
+1: movl %eax, 0(%edi)
+ addl $0x00200000, %eax
+ addl $8, %edi
+ decl %ecx
+ jnz 1b
+
+ /* Enable the boot page tables */
+ leal pgtable(%ebx), %eax
+ movl %eax, %cr3
+
+ /* Enable Long mode in EFER (Extended Feature Enable Register) */
+ movl $MSR_EFER, %ecx
+ rdmsr
+ btsl $_EFER_LME, %eax
+ wrmsr
+
+ /* Setup for the jump to 64bit mode
+ *
+ * When the jump is performend we will be in long mode but
+ * in 32bit compatibility mode with EFER.LME = 1, CS.L = 0, CS.D = 1
+ * (and in turn EFER.LMA = 1). To jump into 64bit mode we use
+ * the new gdt/idt that has __KERNEL_CS with CS.L = 1.
+ * We place all of the values on our mini stack so lret can
+ * used to perform that far jump.
+ */
+ pushl $__KERNEL_CS
+ leal startup_64(%ebp), %eax
+ pushl %eax
+
+ /* Enter paged protected Mode, activating Long Mode */
+ movl $0x80000001, %eax /* Enable Paging and Protected mode */
+ movl %eax, %cr0
+
+ /* Jump from 32bit compatibility mode into 64bit mode. */
+ lret
+
+ /* Be careful here startup_64 needs to be at a predictable
+ * address so I can export it in an ELF header. Bootloaders
+ * should look at the ELF header to find this address, as
+ * it may change in the future.
+ */
+ .code64
+ .org 0x100
+ENTRY(startup_64)
+ /* We come here either from startup_32 or directly from a
+ * 64bit bootloader. If we come here from a bootloader we depend on
+ * an identity mapped page table being provied that maps our
+ * entire text+data+bss and hopefully all of memory.
+ */
+
+ /* Setup data segments. */
+ xorl %eax, %eax
+ movl %eax, %ds
+ movl %eax, %es
+ movl %eax, %ss
+
+ /* Compute the decompressed kernel start address. It is where
+ * we were loaded at aligned to a 2M boundary. %rbp contains the
+ * decompressed kernel start address.
+ *
+ * If it is a relocatable kernel then decompress and run the kernel
+ * from load address aligned to 2MB addr, otherwise decompress and
+ * run the kernel from CONFIG_PHYSICAL_START
+ */
+
+ /* Start with the delta to where the kernel will run at. */
+#ifdef CONFIG_RELOCATABLE
+ leaq startup_32(%rip) /* - $startup_32 */, %rbp
+ addq $(LARGE_PAGE_SIZE - 1), %rbp
+ andq $LARGE_PAGE_MASK, %rbp
+ movq %rbp, %rbx
+#else
+ movq $CONFIG_PHYSICAL_START, %rbp
+ movq %rbp, %rbx
+#endif
+
+ /* Replace the compressed data size with the uncompressed size */
+ movl input_len(%rip), %eax
+ subq %rax, %rbx
+ movl output_len(%rip), %eax
+ addq %rax, %rbx
+ /* Add 8 bytes for every 32K input block */
+ shrq $12, %rax
+ addq %rax, %rbx
+ /* Add 32K + 18 bytes of extra slack and align on a 4K boundary */
+ addq $(32768 + 18 + 4095), %rbx
+ andq $~4095, %rbx
+
+/* Copy the compressed kernel to the end of our buffer
+ * where decompression in place becomes safe.
+ */
+ leaq _end(%rip), %r8
+ leaq _end(%rbx), %r9
+ movq $_end /* - $startup_32 */, %rcx
+1: subq $8, %r8
+ subq $8, %r9
+ movq 0(%r8), %rax
+ movq %rax, 0(%r9)
+ subq $8, %rcx
+ jnz 1b
+
+/*
+ * Jump to the relocated address.
+ */
+ leaq relocated(%rbx), %rax
+ jmp *%rax
+
+.section ".text"
+relocated:
+