spi: spi_bfin: resequence DMA start/stop
authorSonic Zhang <sonic.zhang@analog.com>
Wed, 5 Dec 2007 07:45:21 +0000 (23:45 -0800)
committerLinus Torvalds <torvalds@woody.linux-foundation.org>
Wed, 5 Dec 2007 17:21:20 +0000 (09:21 -0800)
Set correct baud for spi mmc and enable SPI only after DMA is started.

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
drivers/spi/spi_bfin5xx.c

index 4dc7e67493220866e1c70bc8414298518d321f5b..a85bcb306590136c38941b84e4b4630731a63700 100644 (file)
@@ -231,13 +231,13 @@ static int restore_state(struct driver_data *drv_data)
        dev_dbg(&drv_data->pdev->dev, "restoring spi ctl state\n");
 
        /* Load the registers */
-       cs_deactive(drv_data, chip);
        write_BAUD(drv_data, chip->baud);
        chip->ctl_reg &= (~BIT_CTL_TIMOD);
        chip->ctl_reg |= (chip->width << 8);
        write_CTRL(drv_data, chip->ctl_reg);
 
        bfin_spi_enable(drv_data);
+       cs_active(drv_data, chip);
 
        if (ret)
                dev_dbg(&drv_data->pdev->dev,
@@ -767,6 +767,7 @@ static void pump_transfers(unsigned long data)
 
                disable_dma(drv_data->dma_channel);
                clear_dma_irqstat(drv_data->dma_channel);
+               bfin_spi_disable(drv_data);
 
                /* config dma channel */
                dev_dbg(&drv_data->pdev->dev, "doing dma transfer\n");
@@ -789,9 +790,6 @@ static void pump_transfers(unsigned long data)
                        dev_dbg(&drv_data->pdev->dev,
                                "doing autobuffer DMA out.\n");
 
-                       /* set SPI transfer mode */
-                       write_CTRL(drv_data, (cr | CFG_SPI_DMAWRITE));
-
                        /* no irq in autobuffer mode */
                        dma_config =
                            (DMAFLOW_AUTO | RESTART | dma_width | DI_EN);
@@ -800,7 +798,13 @@ static void pump_transfers(unsigned long data)
                                        (unsigned long)drv_data->tx);
                        enable_dma(drv_data->dma_channel);
 
-                       /* just return here, there can only be one transfer in this mode */
+                       /* start SPI transfer */
+                       write_CTRL(drv_data,
+                               (cr | CFG_SPI_DMAWRITE | BIT_CTL_ENABLE));
+
+                       /* just return here, there can only be one transfer
+                        * in this mode
+                        */
                        message->status = 0;
                        giveback(drv_data);
                        return;
@@ -811,9 +815,6 @@ static void pump_transfers(unsigned long data)
                        /* set transfer mode, and enable SPI */
                        dev_dbg(&drv_data->pdev->dev, "doing DMA in.\n");
 
-                       /* set SPI transfer mode */
-                       write_CTRL(drv_data, (cr | CFG_SPI_DMAREAD));
-
                        /* clear tx reg soformer data is not shifted out */
                        write_TDBR(drv_data, 0xFFFF);
 
@@ -827,12 +828,13 @@ static void pump_transfers(unsigned long data)
                                        (unsigned long)drv_data->rx);
                        enable_dma(drv_data->dma_channel);
 
+                       /* start SPI transfer */
+                       write_CTRL(drv_data,
+                               (cr | CFG_SPI_DMAREAD | BIT_CTL_ENABLE));
+
                } else if (drv_data->tx != NULL) {
                        dev_dbg(&drv_data->pdev->dev, "doing DMA out.\n");
 
-                       /* set SPI transfer mode */
-                       write_CTRL(drv_data, (cr | CFG_SPI_DMAWRITE));
-
                        /* start dma */
                        dma_enable_irq(drv_data->dma_channel);
                        dma_config = (RESTART | dma_width | DI_EN);
@@ -840,6 +842,10 @@ static void pump_transfers(unsigned long data)
                        set_dma_start_addr(drv_data->dma_channel,
                                        (unsigned long)drv_data->tx);
                        enable_dma(drv_data->dma_channel);
+
+                       /* start SPI transfer */
+                       write_CTRL(drv_data,
+                               (cr | CFG_SPI_DMAWRITE | BIT_CTL_ENABLE));
                }
        } else {
                /* IO mode write then read */
@@ -1142,6 +1148,8 @@ static int setup(struct spi_device *spi)
                peripheral_request(ssel[spi->master->bus_num]
                        [chip->chip_select_num-1], DRV_NAME);
 
+       cs_deactive(drv_data, chip);
+
        return 0;
 }