gpio/lynxpoint: check if the interrupt is enabled in IRQ handler

commit 03d152d5582abc8a1c19cb107164c3724bbd4be4 upstream.

Checking LP_INT_STAT is not enough in the interrupt handler because its
contents get updated regardless of whether the pin has interrupt enabled or
not. This causes the driver to loop forever for GPIOs that are pulled up.

Fix this by checking the interrupt enable bit for the pin as well.

Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Acked-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/gpio/gpio-lynxpoint.c b/drivers/gpio/gpio-lynxpoint.c
index 86c17de87692c74baca7da4a67455e1745a0cf1e..71d86143aec5e21c394fb5d502606cfaa4863df2 100644 (file)
--- a/drivers/gpio/gpio-lynxpoint.c
+++ b/drivers/gpio/gpio-lynxpoint.c
@@ -248,14 +248,15 @@ static void lp_gpio_irq_handler(unsigned irq, struct irq_desc *desc)
        struct lp_gpio *lg = irq_data_get_irq_handler_data(data);
        struct irq_chip *chip = irq_data_get_irq_chip(data);
        u32 base, pin, mask;
-       unsigned long reg, pending;
+       unsigned long reg, ena, pending;
        unsigned virq;
 
        /* check from GPIO controller which pin triggered the interrupt */
        for (base = 0; base < lg->chip.ngpio; base += 32) {
                reg = lp_gpio_reg(&lg->chip, base, LP_INT_STAT);
+               ena = lp_gpio_reg(&lg->chip, base, LP_INT_ENABLE);
 
-               while ((pending = inl(reg))) {
+               while ((pending = (inl(reg) & inl(ena)))) {
                        pin = __ffs(pending);
                        mask = BIT(pin);
                        /* Clear before handling so we don't lose an edge */