Fix RTL8019AS init for Toshiba RBTX49xx boards
authorSergei Shtylyov <sshtylyov@ru.mvista.com>
Mon, 8 May 2006 20:58:28 +0000 (00:58 +0400)
committerStephen Hemminger <shemminger@osdl.org>
Mon, 8 May 2006 23:00:58 +0000 (16:00 -0700)
    Ensure that 8-bit mode is selected for the on-board Realtek RTL8019AS chip
on Toshiba RBHMA4x00, get rid of the duplicate #ifdef's when setting
ei_status.word16.
    The chip's datasheet says that the PSTOP register shouldn't exceed 0x60 in
8-bit mode -- ensure this too.

Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
drivers/net/ne.c

index 93c494bcd18d67beaf035473f37a77dd7c45171b..b32765215f75c12d983df36349d4f6acbe4e453f 100644 (file)
@@ -139,8 +139,9 @@ bad_clone_list[] __initdata = {
 
 #if defined(CONFIG_PLAT_MAPPI)
 #  define DCR_VAL 0x4b
-#elif defined(CONFIG_PLAT_OAKS32R)
-#  define DCR_VAL 0x48
+#elif defined(CONFIG_PLAT_OAKS32R)  || \
+   defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+#  define DCR_VAL 0x48         /* 8-bit mode */
 #else
 #  define DCR_VAL 0x49
 #endif
@@ -396,10 +397,22 @@ static int __init ne_probe1(struct net_device *dev, int ioaddr)
                /* We must set the 8390 for word mode. */
                outb_p(DCR_VAL, ioaddr + EN0_DCFG);
                start_page = NESM_START_PG;
-               stop_page = NESM_STOP_PG;
+
+               /*
+                * Realtek RTL8019AS datasheet says that the PSTOP register
+                * shouldn't exceed 0x60 in 8-bit mode.
+                * This chip can be identified by reading the signature from
+                * the  remote byte count registers (otherwise write-only)...
+                */
+               if ((DCR_VAL & 0x01) == 0 &&            /* 8-bit mode */
+                   inb(ioaddr + EN0_RCNTLO) == 0x50 &&
+                   inb(ioaddr + EN0_RCNTHI) == 0x70)
+                       stop_page = 0x60;
+               else
+                       stop_page = NESM_STOP_PG;
        } else {
                start_page = NE1SM_START_PG;
-               stop_page = NE1SM_STOP_PG;
+               stop_page  = NE1SM_STOP_PG;
        }
 
 #if  defined(CONFIG_PLAT_MAPPI) || defined(CONFIG_PLAT_OAKS32R)
@@ -509,15 +522,9 @@ static int __init ne_probe1(struct net_device *dev, int ioaddr)
        ei_status.name = name;
        ei_status.tx_start_page = start_page;
        ei_status.stop_page = stop_page;
-#if defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
-       wordlength = 1;
-#endif
 
-#ifdef CONFIG_PLAT_OAKS32R
-       ei_status.word16 = 0;
-#else
-       ei_status.word16 = (wordlength == 2);
-#endif
+       /* Use 16-bit mode only if this wasn't overridden by DCR_VAL */
+       ei_status.word16 = (wordlength == 2 && (DCR_VAL & 0x01));
 
        ei_status.rx_start_page = start_page + TX_PAGES;
 #ifdef PACKETBUF_MEMSIZE