#define DRIVER_NAME "da8xx_lcdc"
+#define LCD_VERSION_1 1
+#define LCD_VERSION_2 2
+
/* LCD Status Register */
#define LCD_END_OF_FRAME1 BIT(9)
#define LCD_END_OF_FRAME0 BIT(8)
#define LCD_DMA_BURST_4 0x2
#define LCD_DMA_BURST_8 0x3
#define LCD_DMA_BURST_16 0x4
-#define LCD_END_OF_FRAME_INT_ENA BIT(2)
+#define LCD_V1_END_OF_FRAME_INT_ENA BIT(2)
+#define LCD_V2_END_OF_FRAME0_INT_ENA BIT(8)
+#define LCD_V2_END_OF_FRAME1_INT_ENA BIT(9)
#define LCD_DUAL_FRAME_BUFFER_ENABLE BIT(0)
/* LCD Control Register */
#define LCD_MONO_8BIT_MODE BIT(9)
#define LCD_RASTER_ORDER BIT(8)
#define LCD_TFT_MODE BIT(7)
-#define LCD_UNDERFLOW_INT_ENA BIT(6)
-#define LCD_PL_ENABLE BIT(4)
+#define LCD_V1_UNDERFLOW_INT_ENA BIT(6)
+#define LCD_V2_UNDERFLOW_INT_ENA BIT(5)
+#define LCD_V1_PL_INT_ENA BIT(4)
+#define LCD_V2_PL_INT_ENA BIT(6)
#define LCD_MONOCHROME_MODE BIT(1)
#define LCD_RASTER_ENABLE BIT(0)
#define LCD_TFT_ALT_ENABLE BIT(23)
#define LCD_STN_565_ENABLE BIT(24)
+#define LCD_V2_DMA_CLK_EN BIT(2)
+#define LCD_V2_LIDD_CLK_EN BIT(1)
+#define LCD_V2_CORE_CLK_EN BIT(0)
+#define LCD_V2_LPP_B10 26
/* LCD Raster Timing 2 Register */
#define LCD_AC_BIAS_TRANSITIONS_PER_INT(x) ((x) << 16)
#define LCD_INVERT_FRAME_CLOCK BIT(20)
/* LCD Block */
+#define LCD_PID_REG 0x0
#define LCD_CTRL_REG 0x4
#define LCD_STAT_REG 0x8
#define LCD_RASTER_CTRL_REG 0x28
#define LCD_DMA_FRM_BUF_BASE_ADDR_1_REG 0x4C
#define LCD_DMA_FRM_BUF_CEILING_ADDR_1_REG 0x50
+/* Interrupt Registers available only in Version 2 */
+#define LCD_RAW_STAT_REG 0x58
+#define LCD_MASKED_STAT_REG 0x5c
+#define LCD_INT_ENABLE_SET_REG 0x60
+#define LCD_INT_ENABLE_CLR_REG 0x64
+#define LCD_END_OF_INT_IND_REG 0x68
+
+/* Clock registers available only on Version 2 */
+#define LCD_CLK_ENABLE_REG 0x6c
+#define LCD_CLK_RESET_REG 0x70
+
#define LCD_NUM_BUFFERS 2
#define WSI_TIMEOUT 50
static resource_size_t da8xx_fb_reg_base;
static struct resource *lcdc_regs;
+static unsigned int lcd_revision;
+static irq_handler_t lcdc_irq_handler;
static inline unsigned int lcdc_read(unsigned int addr)
{
u32 end;
u32 reg_ras;
u32 reg_dma;
+ u32 reg_int;
/* init reg to clear PLM (loading mode) fields */
reg_ras = lcdc_read(LCD_RASTER_CTRL_REG);
end = par->dma_end;
reg_ras |= LCD_PALETTE_LOAD_MODE(DATA_ONLY);
- reg_dma |= LCD_END_OF_FRAME_INT_ENA;
+ if (lcd_revision == LCD_VERSION_1) {
+ reg_dma |= LCD_V1_END_OF_FRAME_INT_ENA;
+ } else {
+ reg_int = lcdc_read(LCD_INT_ENABLE_SET_REG) |
+ LCD_V2_END_OF_FRAME0_INT_ENA |
+ LCD_V2_END_OF_FRAME1_INT_ENA;
+ lcdc_write(reg_int, LCD_INT_ENABLE_SET_REG);
+ }
reg_dma |= LCD_DUAL_FRAME_BUFFER_ENABLE;
lcdc_write(start, LCD_DMA_FRM_BUF_BASE_ADDR_0_REG);
end = start + par->palette_sz - 1;
reg_ras |= LCD_PALETTE_LOAD_MODE(PALETTE_ONLY);
- reg_ras |= LCD_PL_ENABLE;
+
+ if (lcd_revision == LCD_VERSION_1) {
+ reg_ras |= LCD_V1_PL_INT_ENA;
+ } else {
+ reg_int = lcdc_read(LCD_INT_ENABLE_SET_REG) |
+ LCD_V2_PL_INT_ENA;
+ lcdc_write(reg_int, LCD_INT_ENABLE_SET_REG);
+ }
lcdc_write(start, LCD_DMA_FRM_BUF_BASE_ADDR_0_REG);
lcdc_write(end, LCD_DMA_FRM_BUF_CEILING_ADDR_0_REG);
static int lcd_cfg_display(const struct lcd_ctrl_config *cfg)
{
u32 reg;
+ u32 reg_int;
reg = lcdc_read(LCD_RASTER_CTRL_REG) & ~(LCD_TFT_MODE |
LCD_MONO_8BIT_MODE |
}
/* enable additional interrupts here */
- reg |= LCD_UNDERFLOW_INT_ENA;
+ if (lcd_revision == LCD_VERSION_1) {
+ reg |= LCD_V1_UNDERFLOW_INT_ENA;
+ } else {
+ reg_int = lcdc_read(LCD_INT_ENABLE_SET_REG) |
+ LCD_V2_UNDERFLOW_INT_ENA;
+ lcdc_write(reg_int, LCD_INT_ENABLE_SET_REG);
+ }
lcdc_write(reg, LCD_RASTER_CTRL_REG);
/* DMA has to be disabled */
lcdc_write(0, LCD_DMA_CTRL_REG);
lcdc_write(0, LCD_RASTER_CTRL_REG);
+
+ if (lcd_revision == LCD_VERSION_2)
+ lcdc_write(0, LCD_INT_ENABLE_SET_REG);
}
static void lcd_calc_clk_divider(struct da8xx_fb_par *par)
/* Configure the LCD clock divisor. */
lcdc_write(LCD_CLK_DIVISOR(div) |
(LCD_RASTER_MODE & 0x1), LCD_CTRL_REG);
+
+ if (lcd_revision == LCD_VERSION_2)
+ lcdc_write(LCD_V2_DMA_CLK_EN | LCD_V2_LIDD_CLK_EN |
+ LCD_V2_CORE_CLK_EN, LCD_CLK_ENABLE_REG);
+
}
static int lcd_init(struct da8xx_fb_par *par, const struct lcd_ctrl_config *cfg,
return 0;
}
-static irqreturn_t lcdc_irq_handler(int irq, void *arg)
+/* IRQ handler for version 2 of LCDC */
+static irqreturn_t lcdc_irq_handler_rev02(int irq, void *arg)
+{
+ struct da8xx_fb_par *par = arg;
+ u32 stat = lcdc_read(LCD_MASKED_STAT_REG);
+ u32 reg_int;
+
+ if ((stat & LCD_SYNC_LOST) && (stat & LCD_FIFO_UNDERFLOW)) {
+ lcd_disable_raster();
+ lcdc_write(stat, LCD_MASKED_STAT_REG);
+ lcd_enable_raster();
+ } else if (stat & LCD_PL_LOAD_DONE) {
+ /*
+ * Must disable raster before changing state of any control bit.
+ * And also must be disabled before clearing the PL loading
+ * interrupt via the following write to the status register. If
+ * this is done after then one gets multiple PL done interrupts.
+ */
+ lcd_disable_raster();
+
+ lcdc_write(stat, LCD_MASKED_STAT_REG);
+
+ /* Disable PL completion inerrupt */
+ reg_int = lcdc_read(LCD_INT_ENABLE_CLR_REG) |
+ (LCD_V2_PL_INT_ENA);
+ lcdc_write(reg_int, LCD_INT_ENABLE_CLR_REG);
+
+ /* Setup and start data loading mode */
+ lcd_blit(LOAD_DATA, par);
+ } else {
+ lcdc_write(stat, LCD_MASKED_STAT_REG);
+
+ if (stat & LCD_END_OF_FRAME0) {
+ lcdc_write(par->dma_start,
+ LCD_DMA_FRM_BUF_BASE_ADDR_0_REG);
+ lcdc_write(par->dma_end,
+ LCD_DMA_FRM_BUF_CEILING_ADDR_0_REG);
+ par->vsync_flag = 1;
+ wake_up_interruptible(&par->vsync_wait);
+ }
+
+ if (stat & LCD_END_OF_FRAME1) {
+ lcdc_write(par->dma_start,
+ LCD_DMA_FRM_BUF_BASE_ADDR_1_REG);
+ lcdc_write(par->dma_end,
+ LCD_DMA_FRM_BUF_CEILING_ADDR_1_REG);
+ par->vsync_flag = 1;
+ wake_up_interruptible(&par->vsync_wait);
+ }
+ }
+
+ lcdc_write(0, LCD_END_OF_INT_IND_REG);
+ return IRQ_HANDLED;
+}
+
+/* IRQ handler for version 1 LCDC */
+static irqreturn_t lcdc_irq_handler_rev01(int irq, void *arg)
{
struct da8xx_fb_par *par = arg;
u32 stat = lcdc_read(LCD_STAT_REG);
/* Disable PL completion inerrupt */
reg_ras = lcdc_read(LCD_RASTER_CTRL_REG);
- reg_ras &= ~LCD_PL_ENABLE;
+ reg_ras &= ~LCD_V1_PL_INT_ENA;
lcdc_write(reg_ras, LCD_RASTER_CTRL_REG);
/* Setup and start data loading mode */
if (ret)
goto err_clk_put;
+ /* Determine LCD IP Version */
+ switch (lcdc_read(LCD_PID_REG)) {
+ case 0x4C100102:
+ lcd_revision = LCD_VERSION_1;
+ break;
+ case 0x4F200800:
+ lcd_revision = LCD_VERSION_2;
+ break;
+ default:
+ dev_warn(&device->dev, "Unknown PID Reg value 0x%x, "
+ "defaulting to LCD revision 1\n",
+ lcdc_read(LCD_PID_REG));
+ lcd_revision = LCD_VERSION_1;
+ break;
+ }
+
for (i = 0, lcdc_info = known_lcd_panels;
i < ARRAY_SIZE(known_lcd_panels);
i++, lcdc_info++) {
}
#endif
- ret = request_irq(par->irq, lcdc_irq_handler, 0, DRIVER_NAME, par);
+ if (lcd_revision == LCD_VERSION_1)
+ lcdc_irq_handler = lcdc_irq_handler_rev01;
+ else
+ lcdc_irq_handler = lcdc_irq_handler_rev02;
+
+ ret = request_irq(par->irq, lcdc_irq_handler, 0,
+ DRIVER_NAME, par);
if (ret)
goto irq_freq;
return 0;
projects / firefly-linux-kernel-4.4.55.git / commitdiff