ide-disk: use ata_id_hpa_enabled()
authorBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Fri, 10 Oct 2008 20:39:20 +0000 (22:39 +0200)
committerBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Fri, 10 Oct 2008 20:39:20 +0000 (22:39 +0200)
idedisk_supports_hpa() -> ata_id_hpa_enabled().

The latter one also checks validity of words 82 & 85.

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
drivers/ide/ide-disk.c

index 696658d504db6ade5325904d8b315e0e32a0a87c..40253c51ace4ee8bbd49aeaf060b895cb2106215 100644 (file)
@@ -385,17 +385,6 @@ static unsigned long long sectors_to_MB(unsigned long long n)
        return n;
 }
 
-/*
- * Bits 10 of command_set_1 and cfs_enable_1 must be equal,
- * so on non-buggy drives we need test only one.
- * However, we should also check whether these fields are valid.
- */
-static inline int idedisk_supports_hpa(const u16 *id)
-{
-       return (id[ATA_ID_COMMAND_SET_1] & 0x0400) &&
-              (id[ATA_ID_CFS_ENABLE_1] & 0x0400);
-}
-
 /*
  * The same here.
  */
@@ -461,7 +450,7 @@ static void init_idedisk_capacity(ide_drive_t *drive)
         * If this drive supports the Host Protected Area feature set,
         * then we may need to change our opinion about the drive's capacity.
         */
-       int hpa = idedisk_supports_hpa(id);
+       int hpa = ata_id_hpa_enabled(id);
 
        if (idedisk_supports_lba48(id)) {
                /* drive speaks 48-bit LBA */
@@ -939,7 +928,7 @@ static int ide_disk_probe(ide_drive_t *drive);
  */
 static void ide_disk_resume(ide_drive_t *drive)
 {
-       if (idedisk_supports_hpa(drive->id))
+       if (ata_id_hpa_enabled(drive->id))
                init_idedisk_capacity(drive);
 }