From: Daniel Mack Date: Mon, 24 Jun 2013 14:31:30 +0000 (+0200) Subject: ASoC: adau1701: allow configuration of PLL mode pins X-Git-Tag: firefly_0821_release~176^2~5710^2~6^2~5^2~4 X-Git-Url: http://demsky.eecs.uci.edu/git/?a=commitdiff_plain;h=2352d4bf43b105ec2da5f43211db4a4c9bf34d4e;p=firefly-linux-kernel-4.4.55.git ASoC: adau1701: allow configuration of PLL mode pins The ADAU1701 has 2 hardware pins to configure the PLL mode in accordance to the MCLK-to-LRCLK ratio. These pins have to be stable before the chip is released from reset, and a full reset cycle, including a new firmware download is needed whenever they change. This patch adds GPIO properties to the DT bindings of the Codec, and implements makes the set_sysclk memorize the configured sysclk. Because the run-time parameters are unknown at probe time, the first firmware download is postponed to the first hw_params call, when the driver can determine the mclk/lrclk divider. Subsequent downloads are only issued when the divider configuration changes. Signed-off-by: Daniel Mack Acked-by: Lars-Peter Clausen Signed-off-by: Mark Brown --- diff --git a/Documentation/devicetree/bindings/sound/adi,adau1701.txt b/Documentation/devicetree/bindings/sound/adi,adau1701.txt index 3afeda77b5b9..a9fbed1be40e 100644 --- a/Documentation/devicetree/bindings/sound/adi,adau1701.txt +++ b/Documentation/devicetree/bindings/sound/adi,adau1701.txt @@ -11,6 +11,11 @@ Optional properties: - reset-gpio: A GPIO spec to define which pin is connected to the chip's !RESET pin. If specified, the driver will assert a hardware reset at probe time. + - adi,pll-mode-gpios: An array of two GPIO specs to describe the GPIOs + the ADAU's PLL config pins are connected to. + The state of the pins are set according to the + configured clock divider on ASoC side before the + firmware is loaded. Examples: @@ -19,5 +24,6 @@ Examples: compatible = "adi,adau1701"; reg = <0x34>; reset-gpio = <&gpio 23 0>; + adi,pll-mode-gpios = <&gpio 24 0 &gpio 25 0>; }; }; diff --git a/sound/soc/codecs/adau1701.c b/sound/soc/codecs/adau1701.c index 997fc3b881fe..770d90ee5f92 100644 --- a/sound/soc/codecs/adau1701.c +++ b/sound/soc/codecs/adau1701.c @@ -87,11 +87,16 @@ #define ADAU1701_OSCIPOW_OPD 0x04 #define ADAU1701_DACSET_DACINIT 1 +#define ADAU1707_CLKDIV_UNSET (-1UL) + #define ADAU1701_FIRMWARE "adau1701.bin" struct adau1701 { int gpio_nreset; + int gpio_pll_mode[2]; unsigned int dai_fmt; + unsigned int pll_clkdiv; + unsigned int sysclk; }; static const struct snd_kcontrol_new adau1701_controls[] = { @@ -184,12 +189,38 @@ static unsigned int adau1701_read(struct snd_soc_codec *codec, unsigned int reg) return value; } -static int adau1701_reset(struct snd_soc_codec *codec) +static int adau1701_reset(struct snd_soc_codec *codec, unsigned int clkdiv) { struct adau1701 *adau1701 = snd_soc_codec_get_drvdata(codec); struct i2c_client *client = to_i2c_client(codec->dev); int ret; + if (clkdiv != ADAU1707_CLKDIV_UNSET && + gpio_is_valid(adau1701->gpio_pll_mode[0]) && + gpio_is_valid(adau1701->gpio_pll_mode[1])) { + switch (clkdiv) { + case 64: + gpio_set_value(adau1701->gpio_pll_mode[0], 0); + gpio_set_value(adau1701->gpio_pll_mode[1], 0); + break; + case 256: + gpio_set_value(adau1701->gpio_pll_mode[0], 0); + gpio_set_value(adau1701->gpio_pll_mode[1], 1); + break; + case 384: + gpio_set_value(adau1701->gpio_pll_mode[0], 1); + gpio_set_value(adau1701->gpio_pll_mode[1], 0); + break; + case 0: /* fallback */ + case 512: + gpio_set_value(adau1701->gpio_pll_mode[0], 1); + gpio_set_value(adau1701->gpio_pll_mode[1], 1); + break; + } + } + + adau1701->pll_clkdiv = clkdiv; + if (gpio_is_valid(adau1701->gpio_nreset)) { gpio_set_value(adau1701->gpio_nreset, 0); /* minimum reset time is 20ns */ @@ -199,10 +230,16 @@ static int adau1701_reset(struct snd_soc_codec *codec) mdelay(85); } - ret = process_sigma_firmware(client, ADAU1701_FIRMWARE); - if (ret) { - dev_warn(codec->dev, "Failed to load firmware\n"); - return ret; + /* + * Postpone the firmware download to a point in time when we + * know the correct PLL setup + */ + if (clkdiv != ADAU1707_CLKDIV_UNSET) { + ret = process_sigma_firmware(client, ADAU1701_FIRMWARE); + if (ret) { + dev_warn(codec->dev, "Failed to load firmware\n"); + return ret; + } } snd_soc_write(codec, ADAU1701_DACSET, ADAU1701_DACSET_DACINIT); @@ -285,8 +322,22 @@ static int adau1701_hw_params(struct snd_pcm_substream *substream, struct snd_pcm_hw_params *params, struct snd_soc_dai *dai) { struct snd_soc_codec *codec = dai->codec; + struct adau1701 *adau1701 = snd_soc_codec_get_drvdata(codec); + unsigned int clkdiv = adau1701->sysclk / params_rate(params); snd_pcm_format_t format; unsigned int val; + int ret; + + /* + * If the mclk/lrclk ratio changes, the chip needs updated PLL + * mode GPIO settings, and a full reset cycle, including a new + * firmware upload. + */ + if (clkdiv != adau1701->pll_clkdiv) { + ret = adau1701_reset(codec, clkdiv); + if (ret < 0) + return ret; + } switch (params_rate(params)) { case 192000: @@ -429,6 +480,7 @@ static int adau1701_set_sysclk(struct snd_soc_codec *codec, int clk_id, int source, unsigned int freq, int dir) { unsigned int val; + struct adau1701 *adau1701 = snd_soc_codec_get_drvdata(codec); switch (clk_id) { case ADAU1701_CLK_SRC_OSC: @@ -442,6 +494,7 @@ static int adau1701_set_sysclk(struct snd_soc_codec *codec, int clk_id, } snd_soc_update_bits(codec, ADAU1701_OSCIPOW, ADAU1701_OSCIPOW_OPD, val); + adau1701->sysclk = freq; return 0; } @@ -489,11 +542,21 @@ MODULE_DEVICE_TABLE(of, adau1701_dt_ids); static int adau1701_probe(struct snd_soc_codec *codec) { int ret; + struct adau1701 *adau1701 = snd_soc_codec_get_drvdata(codec); codec->control_data = to_i2c_client(codec->dev); - ret = adau1701_reset(codec); - if (ret) + /* + * Let the pll_clkdiv variable default to something that won't happen + * at runtime. That way, we can postpone the firmware download from + * adau1701_reset() to a point in time when we know the correct PLL + * mode parameters. + */ + adau1701->pll_clkdiv = ADAU1707_CLKDIV_UNSET; + + /* initalize with pre-configured pll mode settings */ + ret = adau1701_reset(codec, adau1701->pll_clkdiv); + if (ret < 0) return ret; return 0; @@ -526,6 +589,7 @@ static int adau1701_i2c_probe(struct i2c_client *client, struct adau1701 *adau1701; struct device *dev = &client->dev; int gpio_nreset = -EINVAL; + int gpio_pll_mode[2] = { -EINVAL, -EINVAL }; int ret; adau1701 = devm_kzalloc(dev, sizeof(*adau1701), GFP_KERNEL); @@ -536,6 +600,16 @@ static int adau1701_i2c_probe(struct i2c_client *client, gpio_nreset = of_get_named_gpio(dev->of_node, "reset-gpio", 0); if (gpio_nreset < 0 && gpio_nreset != -ENOENT) return gpio_nreset; + + gpio_pll_mode[0] = of_get_named_gpio(dev->of_node, + "adi,pll-mode-gpios", 0); + if (gpio_pll_mode[0] < 0 && gpio_pll_mode[0] != -ENOENT) + return gpio_pll_mode[0]; + + gpio_pll_mode[1] = of_get_named_gpio(dev->of_node, + "adi,pll-mode-gpios", 1); + if (gpio_pll_mode[1] < 0 && gpio_pll_mode[1] != -ENOENT) + return gpio_pll_mode[1]; } if (gpio_is_valid(gpio_nreset)) { @@ -545,7 +619,24 @@ static int adau1701_i2c_probe(struct i2c_client *client, return ret; } + if (gpio_is_valid(gpio_pll_mode[0]) && + gpio_is_valid(gpio_pll_mode[1])) { + ret = devm_gpio_request_one(dev, gpio_pll_mode[0], + GPIOF_OUT_INIT_LOW, + "ADAU1701 PLL mode 0"); + if (ret < 0) + return ret; + + ret = devm_gpio_request_one(dev, gpio_pll_mode[1], + GPIOF_OUT_INIT_LOW, + "ADAU1701 PLL mode 1"); + if (ret < 0) + return ret; + } + adau1701->gpio_nreset = gpio_nreset; + adau1701->gpio_pll_mode[0] = gpio_pll_mode[0]; + adau1701->gpio_pll_mode[1] = gpio_pll_mode[1]; i2c_set_clientdata(client, adau1701); ret = snd_soc_register_codec(&client->dev, &adau1701_codec_drv,