From: YoungJun Cho Date: Thu, 17 Jul 2014 09:01:18 +0000 (+0900) Subject: ARM: dts: samsung-fimd: add LCD I80 interface specific properties X-Git-Tag: firefly_0821_release~176^2~3450^2~23^2~29 X-Git-Url: http://demsky.eecs.uci.edu/git/?a=commitdiff_plain;h=8e1c06cf65819d9e0fff061324f9f7edff83583e;p=firefly-linux-kernel-4.4.55.git ARM: dts: samsung-fimd: add LCD I80 interface specific properties In case of using MIPI DSI based I80 interface panel, the relevant registers should be set. So this patch adds relevant DT bindings. Signed-off-by: YoungJun Cho Acked-by: Inki Dae Acked-by: Kyungmin Park Signed-off-by: Inki Dae --- diff --git a/Documentation/devicetree/bindings/video/samsung-fimd.txt b/Documentation/devicetree/bindings/video/samsung-fimd.txt index 2dad41b689af..8428fcff8037 100644 --- a/Documentation/devicetree/bindings/video/samsung-fimd.txt +++ b/Documentation/devicetree/bindings/video/samsung-fimd.txt @@ -44,6 +44,34 @@ Optional Properties: - display-timings: timing settings for FIMD, as described in document [1]. Can be used in case timings cannot be provided otherwise or to override timings provided by the panel. +- samsung,sysreg: handle to syscon used to control the system registers +- i80-if-timings: timing configuration for lcd i80 interface support. + - cs-setup: clock cycles for the active period of address signal is enabled + until chip select is enabled. + If not specified, the default value(0) will be used. + - wr-setup: clock cycles for the active period of CS signal is enabled until + write signal is enabled. + If not specified, the default value(0) will be used. + - wr-active: clock cycles for the active period of CS is enabled. + If not specified, the default value(1) will be used. + - wr-hold: clock cycles for the active period of CS is disabled until write + signal is disabled. + If not specified, the default value(0) will be used. + + The parameters are defined as: + + VCLK(internal) __|??????|_____|??????|_____|??????|_____|??????|_____|?? + : : : : : + Address Output --:| : : : + Chip Select ???????????????|____________:____________:____________|?? + | wr-setup+1 | | wr-hold+1 | + |<---------->| |<---------->| + Write Enable ????????????????????????????|____________|??????????????? + | wr-active+1| + |<---------->| + Video Data ------------------------------ The device node can contain 'port' child nodes according to the bindings defined in [2]. The following are properties specific to those nodes: