From 6f4728c5e5c633b3df618bdec067c80cbb446d3b Mon Sep 17 00:00:00 2001 From: Ben Dooks Date: Mon, 27 Apr 2015 15:19:10 +0200 Subject: [PATCH] ARM: at91/dt: sama5d3 xplained: fill in mmc1 and set it to disabled The mmc1 channel is not populated on the SAM5D3 Xplained board, however it is enabled and therefore the driver is attaching to it. The node configuration for mmc1 is missing, so add an mmc1 node in the device tree and set its status to disabled. Also add the vmmc and the necessary slot configuration if this node were enabled to avoid the following warnings from the driver: atmel_mci f8000000.mmc: No vmmc regulator found atmel_mci f8000000.mmc: No vqmmc regulator found Signed-off-by: Ben Dooks Signed-off-by: Ludovic Desroches Signed-off-by: Nicolas Ferre --- arch/arm/boot/dts/at91-sama5d3_xplained.dts | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts b/arch/arm/boot/dts/at91-sama5d3_xplained.dts index 64636974d7dd..df15587bedcc 100644 --- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts +++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts @@ -43,6 +43,17 @@ }; }; + mmc1: mmc@f8000000 { + vmmc-supply = <&vcc_3v3_reg>; + vqmmc-supply = <&vcc_3v3_reg>; + status = "disabled"; + slot@0 { + reg = <0>; + bus-width = <4>; + cd-gpios = <&pioE 1 GPIO_ACTIVE_LOW>; + }; + }; + spi0: spi@f0004000 { cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>; status = "okay"; -- 2.34.1