From 9aba783a2afd14642f7a28ce23b10af1935a2fcd Mon Sep 17 00:00:00 2001 From: Caesar Wang Date: Fri, 23 Oct 2015 19:25:26 +0800 Subject: [PATCH] dt-bindings: rockchip-thermal: Add the pinctrl states in this document The "init" pinctrl is defined we'll set pinctrl to this state before probe and then "default" after probe. Add the "init" and "sleep" pinctrl as the OTP gpio state, since we need switch the pin to gpio state before the TSADC controller is reset. AFAIK, the TSADC controller is reset, the tshut polarity will be a *low* signal in a short period of time for some devices. Says: The TSADC get the temperature on rockchip thermal. If T(current temperature) < (setting temperature), the OTP output the *high* signal. If T(current temperature) > (setting temperature), the OTP output the *low* Signal. In some cases, the OTP pin is connected to the PMIC, maybe the PMIC can accept the reset response time to avoid this issue. In other words, the system will be always reboot if we make the OTP pin is connected the others IC to control the power. Acked-by: Rob Herring Signed-off-by: Caesar Wang Reviewed-by: Douglas Anderson Signed-off-by: Eduardo Valentin --- .../devicetree/bindings/thermal/rockchip-thermal.txt | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt b/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt index ef802de4957a..b38200d2583a 100644 --- a/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt +++ b/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt @@ -12,6 +12,11 @@ Required properties: - resets : Must contain an entry for each entry in reset-names. See ../reset/reset.txt for details. - reset-names : Must include the name "tsadc-apb". +- pinctrl-names : The pin control state names; +- pinctrl-0 : The "init" pinctrl state, it will be set before device probe. +- pinctrl-1 : The "default" pinctrl state, it will be set after reset the + TSADC controller. +- pinctrl-2 : The "sleep" pinctrl state, it will be in for suspend. - #thermal-sensor-cells : Should be 1. See ./thermal.txt for a description. - rockchip,hw-tshut-temp : The hardware-controlled shutdown temperature value. - rockchip,hw-tshut-mode : The hardware-controlled shutdown mode 0:CRU 1:GPIO. @@ -27,8 +32,10 @@ tsadc: tsadc@ff280000 { clock-names = "tsadc", "apb_pclk"; resets = <&cru SRST_TSADC>; reset-names = "tsadc-apb"; - pinctrl-names = "default"; - pinctrl-0 = <&otp_out>; + pinctrl-names = "init", "default", "sleep"; + pinctrl-0 = <&otp_gpio>; + pinctrl-1 = <&otp_out>; + pinctrl-2 = <&otp_gpio>; #thermal-sensor-cells = <1>; rockchip,hw-tshut-temp = <95000>; rockchip,hw-tshut-mode = <0>; -- 2.34.1