From 9b68f12b57e5241f26c2924637aaae740cc1b276 Mon Sep 17 00:00:00 2001 From: Marc Zyngier Date: Fri, 6 May 2016 19:41:56 +0100 Subject: [PATCH] irqchip/gic-v3: Configure all interrupts as non-secure Group-1 commit 7c9b973061b03af62734f613f6abec46c0dd4a88 upstream. The GICv3 driver wrongly assumes that it runs on the non-secure side of a secure-enabled system, while it could be on a system with a single security state, or a GICv3 with GICD_CTLR.DS set. Either way, it is important to configure this properly, or interrupts will simply not be delivered on this HW. Reported-by: Peter Maydell Tested-by: Peter Maydell Signed-off-by: Marc Zyngier Signed-off-by: Greg Kroah-Hartman --- drivers/irqchip/irq-gic-v3.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) diff --git a/drivers/irqchip/irq-gic-v3.c b/drivers/irqchip/irq-gic-v3.c index e35ab799be12..2fc499a2207e 100644 --- a/drivers/irqchip/irq-gic-v3.c +++ b/drivers/irqchip/irq-gic-v3.c @@ -387,6 +387,15 @@ static void __init gic_dist_init(void) writel_relaxed(0, base + GICD_CTLR); gic_dist_wait_for_rwp(); + /* + * Configure SPIs as non-secure Group-1. This will only matter + * if the GIC only has a single security state. This will not + * do the right thing if the kernel is running in secure mode, + * but that's not the intended use case anyway. + */ + for (i = 32; i < gic_data.irq_nr; i += 32) + writel_relaxed(~0, base + GICD_IGROUPR + i / 8); + gic_dist_config(base, gic_data.irq_nr, gic_dist_wait_for_rwp); /* Enable distributor with ARE, Group1 */ @@ -501,6 +510,9 @@ static void gic_cpu_init(void) rbase = gic_data_rdist_sgi_base(); + /* Configure SGIs/PPIs as non-secure Group-1 */ + writel_relaxed(~0, rbase + GICR_IGROUPR0); + gic_cpu_config(rbase, gic_redist_wait_for_rwp); /* Give LPIs a spin */ -- 2.34.1