From dc03e310a6ae274d7b941c52899dffeeb58d464f Mon Sep 17 00:00:00 2001 From: =?utf8?q?Heiko=20St=C3=BCbner?= Date: Thu, 6 Jun 2013 16:44:25 +0200 Subject: [PATCH] pinctrl: add pinconf-generic define for a pin-default pull There exist controllers that don't support to set the pull to up or down separately but instead automatically set the pull direction based on embedded knowledge inside the controller, for example depending on the selected mux function of the pin. Therefore this patch adds another config option to use this default pull-state for a pin where it is not possible to know or decide if the pin will be pulled up or down. Signed-off-by: Heiko Stuebner Reviewed-by: Stephen Warren Signed-off-by: Linus Walleij --- drivers/pinctrl/pinconf-generic.c | 2 ++ include/linux/pinctrl/pinconf-generic.h | 5 +++++ 2 files changed, 7 insertions(+) diff --git a/drivers/pinctrl/pinconf-generic.c b/drivers/pinctrl/pinconf-generic.c index c3ce85b0888f..794dad7d68d8 100644 --- a/drivers/pinctrl/pinconf-generic.c +++ b/drivers/pinctrl/pinconf-generic.c @@ -41,6 +41,8 @@ static struct pin_config_item conf_items[] = { PCONFDUMP(PIN_CONFIG_BIAS_BUS_HOLD, "input bias bus hold", NULL), PCONFDUMP(PIN_CONFIG_BIAS_PULL_UP, "input bias pull up", NULL), PCONFDUMP(PIN_CONFIG_BIAS_PULL_DOWN, "input bias pull down", NULL), + PCONFDUMP(PIN_CONFIG_BIAS_PULL_PIN_DEFAULT, + "input bias pull to pin specific state", NULL), PCONFDUMP(PIN_CONFIG_DRIVE_PUSH_PULL, "output drive push pull", NULL), PCONFDUMP(PIN_CONFIG_DRIVE_OPEN_DRAIN, "output drive open drain", NULL), PCONFDUMP(PIN_CONFIG_DRIVE_OPEN_SOURCE, "output drive open source", NULL), diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index ac05b3cfeacc..d414a7729424 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -40,6 +40,10 @@ * @PIN_CONFIG_BIAS_PULL_DOWN: the pin will be pulled down (usually with high * impedance to GROUND). If the argument is != 0 pull-down is enabled, * if it is 0, pull-down is disabled. + * @PIN_CONFIG_BIAS_PULL_PIN_DEFAULT: the pin will be pulled up or down based + * on embedded knowledge of the controller, like current mux function. + * If the argument is != 0 pull up/down is enabled, if it is 0, + * the pull is disabled. * @PIN_CONFIG_DRIVE_PUSH_PULL: the pin will be driven actively high and * low, this is the most typical case and is typically achieved with two * active transistors on the output. Setting this config will enable @@ -86,6 +90,7 @@ enum pin_config_param { PIN_CONFIG_BIAS_BUS_HOLD, PIN_CONFIG_BIAS_PULL_UP, PIN_CONFIG_BIAS_PULL_DOWN, + PIN_CONFIG_BIAS_PULL_PIN_DEFAULT, PIN_CONFIG_DRIVE_PUSH_PULL, PIN_CONFIG_DRIVE_OPEN_DRAIN, PIN_CONFIG_DRIVE_OPEN_SOURCE, -- 2.34.1